Note! Not all the calculation functionalities support input to consolidation units. Allowing this might cause major problems.

By default, data can only be entered to input units and consolidation level units that do not have sub-units connected to the same data type. However, you can also allow entering data to consolidation level units which have sub-units connected to the same data type. To do this, use the Parameters custom template. Type the desired value for the AllowConsolidationInput parameter:

•Type "True" if you want to allow entering data to consolidation level units that have sub-units connected to the same data type.

•Type "False" if you do not want to allow entering data to consolidation level units that have sub-units connected to the same data type. In this case, data can only be entered to units defined as input units, and consolidation level units that do not have sub-units connected to the same data type.

Note! If you set the value as "False" when data has already been entered on consolidation levels, the system will not check the existing data and no warning message will be shown when you save the setting. If you are unsure whether data has been entered on consolidation levels, contact your Clausion consultant before changing the setting.